
Tuba Installation Guide Installation
MAN-TUBIG (Ver. 1.502)
www.elmomc.com
51
Figure 29: Analog Inputs Connection Diagram
3.4.8.2. Digital Inputs (on the GENERAL I/O Port)
The Tuba servo drive is equipped with a 25-pin D-Sub plug for digital inputs. When assembling
an I/O cable for digital input follow the instructions in Section 3.4.4 (Feedback and Control
Cable Assemblies) using a 25-pin D-Sub socket with a metal case. The pins are described below.
Pin Signal Function Pin Positions
1 N.C. Not Connected
2 IN10 Programmable input 10
3 IN9 Programmable input 9
4 IN8 Programmable input 8
5 IN7 Programmable input 7
6 N.C. Not Connected
7 IN6 Programmable input 6
8 N.C. Not Connected
9
IN5 Programmable input 5
10
IN4 Programmable input 4
Comentarios a estos manuales