Elmomc AC Input Digital Servo Drives-Tuba Manual de usuario descargar pdf (Pagina 26)

Tuba Installation Guide Installation

MAN-TUBIG (Ver. 1.502)

www.elmomc.com

3.4.2. Connecting the Power Cables

Access the power terminal connections on the Tuba servo drive by removing the front safety

cover located at the bottom of the front panel of the unit, as shown below:

Figure 8: Removable Bottom Panel

After removing the safety cover, the power terminal connections are visible, as follows:

Figure 9: Tuba Power Connectors

The main power connector, which is located at the bottom of the Tuba, has the following pins:

Pin Function Cable Pin Positions

B1 DC Link (+) DC Link

B2 DC Link (-) DC Link

AC3 Phase 3 Power

AC2 Phase 2 Power

AC1 Phase 1 Power

PE Protective earth Power

AC Motor Cable DC Motor Cable

PE Protective earth Motor Motor

M3 Motor phase Motor N/C*

M2 Motor phase Motor Motor

M1 Motor phase Motor Motor*

Note: When connecting several motors, all must be wired in an identical manner.

*On prototype versions of the Tuba, M3 was connected to the Motor and M1 was not.

Table 2: Connector for Main Power and Motor Cables

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 78 79

Sin comentarios

Elmomc AC Input Digital Servo Drives-Tuba Manual de usuario Pagina 26