Elmomc AC Input Digital Servo Drives-Tuba Manual de usuario descargar pdf (Pagina 20)

Tuba Installation Guide Installation

MAN-TUBIG (Ver. 1.502)

www.elmomc.com

3.3. Mounting the Tuba

The Tuba has been designed for two standard mounting options:

• Attaching directly to the wall with screws

• Mounting on a DIN rail

With either type of mounting, be sure to leave about 10 cm (4 in) above and below the

instrument for heat dissipation.

3.3.1. Mounting Directly onto a Wall

The vertical mounting strip at the back of the Tuba enables you to screw the drive directly into

a wall.

To mount the Tuba with the mounting strip:

1. On the back of the drive, push the mounting strip up until it clicks and locks. The top lip

(with the hole) should be exposed.

Figure 3: Extending the Mounting Strip

2. Mount the Tuba vertically onto the wall with two screws, one through the top hole of the

mounting strip and one at the bottom.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 78 79

Sin comentarios

Elmomc AC Input Digital Servo Drives-Tuba Manual de usuario Pagina 20