Elmomc AC Input Digital Servo Drives-Tuba Manual de usuario descargar pdf (Pagina 23)

Tuba Installation Guide Installation

MAN-TUBIG (Ver. 1.502)

www.elmomc.com

• Keep the motor wires as far away as possible from the feedback, control and

communication cables.

• Ensure that in normal operating conditions, the shielded wires and drain carry no current.

The only time these conductors carry current is under abnormal conditions, when electrical

equipment has become a potential shock or fire hazard while conducting external EMI

interferences directly to ground, in order to prevent them from affecting the drive. Failing

to meet this requirement can result in drive/controller/host failure.

• After completing the wiring, carefully inspect all wires to ensure tightness, good solder

joints and general safety.

The Tuba has the following connectors:

Type Function Port on Tuba Connector Location

8-Pin RJ-45 x 2 RS-232 COMM. 1

9-Pin D-Sub socket Analog Input ANALOG I/O

8-Pin RJ-45 x 2 CAN

(In/Out)

COMM. 2

15-Pin high-density

D-Sub socket

Digital Outputs COMMITTED I/O

25-Pin D-Sub plug Digital Inputs GENERAL I/O

15-Pin D-Sub socket Main Feedback FEEDBACK A

15-Pin D-Sub plug Auxiliary Feedback FEEDBACK B

2-Pin terminal strip

Molex

Auxiliary Power

Supply

24V

+, -

10-Pin terminal block

Molex

Mains, Motor

Power & DC Link

B1, B2, M1, M2,

M3, PE, PE, AC1,

AC2, AC3

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 78 79

Sin comentarios

Elmomc AC Input Digital Servo Drives-Tuba Manual de usuario Pagina 23