Elmomc SimplIQ Digital Servo Drives-Bell Command Referenc Manual de usuario descargar pdf (Pagina 280)

0 0.5 1 1.5 2 2.5 3

-8

-6

-4

-2

x 10

Sec

Counts

Figure 6-15: Position Output of the Stop Manager

The input of the stop manager (the output of the position reference generator) is the red

solid line, and the output of the stop manager is the green dashed line. At the time of 0, the

PVT starts at position 17,000. The stop manager catches up with the sinusoidal command,

with an acceleration limit of SD. At the time of 1 second, a Hard Stop switch becomes active

and remains active until the time of 1.2 seconds. The stop manager decelerates the position

command to zero speed, using the SD deceleration. At the time of 1.2 seconds, the stop

manager begins to catch up again with the PVT reference, at SD acceleration.

At the time of approximately 1.7 seconds, the PVT reference nears the limit of

VL[3]= -5000. Before the reference waveform actually reaches -5000, the stop manager finds

that the speed is too great for stopping at VL[3] with a deceleration of SD. It therefore

reduces the speed, coming to a complete stop at VL[3] with very small or no overshoot.

At approximately 2.75 seconds, the stop manager finds that although the position reference

is not yet in range, it will be, in a short time. The stop manager begins to accelerate the motor

into the permitted range so that catching up when the reference returns to range will be

immediate, without the delay of acceleration.

SimplIQ for Steppers Application Note The Position Reference Generator

MAN-STECR (Ver. 1.1)

1 2 ... 275 276 277 278 279 280 281 282 283 284 285 ... 314 315

Sin comentarios

Elmomc SimplIQ Digital Servo Drives-Bell Command Referenc Manual de usuario Pagina 280