Elmomc AC Input Digital Servo Drives-Bassoon Manual de usuario descargar pdf (Pagina 9)

Bassoon Installation Guide Safety Information

MAN-BASIG (Ver. 1.502)

www.elmomc.com

1.1. Warnings

• To avoid electric arcing and hazards to personnel and electrical contacts, never

connect/disconnect the servo drive while the power source is on.

• Power cables can carry a high voltage, even when the motor is not in motion. Disconnect

the Bassoon from all voltage sources before it is opened for servicing.

• The Bassoon servo drive contains grounding conduits for electric current protection. Any

disruption to these conduits may cause the device to become “hot” (live) and dangerous.

• After shutting off the power and removing the power source from your equipment, wait at

least 1 minute before touching or disconnecting parts of the equipment that are normally

loaded with electrical charges (such as capacitors or contacts). Measuring the electrical

contact points with a meter before touching the equipment is recommended.

1.2. Cautions

• The Bassoon servo drive contains hot surfaces and electrically charged components during

operation.

• The maximum AC power supply connected to the instrument must comply with the

parameters outlined in this guide.

• The Bassoon drive must be connected to an approved 24 VDC auxiliary power supply

through a line that is separated from hazardous line voltages using reinforced or double

insulation in accordance with approved safety standards.

• The Bassoon X/230 series is designed to gets its power from a 30 to 255 VAC single phase

power source. It can be connected directly to the line voltage. An isolation transformer is

not needed.

• Before switching on the Bassoon, verify that all safety precautions have been observed and

that the installation procedures in this manual have been followed.

• Do not clean any of the Bassoon drive's soldering with solvent cleaning fluids of pH greater

than 7 (8 to 14). The solvent corrodes the plastic cover causing cracks and eventual damage

to the drive's PCBs.

Elmo recommends using the cleaning fluid Vigon-EFM which is pH Neutral (7).

For further technical information on this recommended cleaning fluid, select the link:

http://www.zestron.com/fileadmin/zestron.com-usa/daten/electronics/Product_TI1s/TI1-

VIGON_EFM-US.pdf

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 68 69

Sin comentarios

Elmomc AC Input Digital Servo Drives-Bassoon Manual de usuario Pagina 9